Bioequivalence and Bioavailability Forum 14:43 CEST

Main page Policy/Terms of Use Abbreviations Latest Posts

 Log in |  Register |  Search

applying correction factor to unknown samples due to stabilization [Bioanalytics]

posted by Mithu - India, 2018-09-06 10:27  - Posting: # 19244
Views: 293

Hi All,

I request you all to correct me if my below mention understanding is not correct.

As per my understanding, whenever we add any stabilizer in study samples immediately after collection of blood samples or after getting plasma separated from the blood we add the stabilizer, we should apply correction factor to the obtain unknown concentrations.

This factor needs to apply only to study samples not to CC & QC prepared. The rational what i believe for this is, unknown samples get little diluted due to addition of stabilization solution and it will not produce true value. Whereas the CC & QC which are also stabilized but here we have known concentration, hence correction factor is not needed to apply because we have % nominal for the acceptance or rejection of the same.

Hence the correction factor applies to get the correct or true concentration of unknown samples only.

Regards,

Mithu

Complete thread:

Back to the forum Activity
 Mix view
Bioequivalence and Bioavailability Forum |  Admin contact
18,700 posts in 3,984 threads, 1,243 registered users;
online 13 (0 registered, 13 guests [including 10 identified bots]).

I suppose it is tempting, if the only tool you have is a hammer,
to treat everything as if it were a nail.    Abraham Maslow

The BIOEQUIVALENCE / BIOAVAILABILITY FORUM is hosted by
BEBAC Ing. Helmut Schütz
HTML5 RSS Feed