is zero positive? [Software]

posted by mittyri – Russia, 2018-07-14 01:31 (2405 d 04:36 ago) – Posting: # 19059
Views: 7,951

Hi Babe_Ruth,

❝ However, when I set BQL to 0, it uses a linear-trapezoidal rule: (Clast + 0)*(T16 - Tlast)

well... let me try to cite it again :-D
If a start or end time falls within the range of the data but does not coincide with an observed data point, then a linear or logarithmic interpolation is done to estimate the corresponding Y, according to the AUC Calculation method selected in the NCA Options. (See “NCA Options tab” on page 42.) Note that logarithmic interpolation is overridden by linear interpolation in the case of a non-positive endpoint.
A question:
is 0 a positive endpoint?

PS: nice to see you are using good oldie 6.3 (decennary next year)

Kind regards,
Mittyri

Complete thread:

UA Flag
Activity
 Admin contact
23,380 posts in 4,914 threads, 1,662 registered users;
24 visitors (0 registered, 24 guests [including 10 identified bots]).
Forum time: 05:07 CET (Europe/Vienna)

Skill is a function of chance.
It’s an intuitive best-use of chance situations.    Philip K. Dick

The Bioequivalence and Bioavailability Forum is hosted by
BEBAC Ing. Helmut Schütz
HTML5