Setup in Phoenix/WinNonlin [Study As­sess­ment]

posted by AngusMcLean – USA, 2016-05-15 17:17 (2896 d 23:00 ago) – Posting: # 16306
Views: 31,094

Helmut: I am having difficulty with Phoenix: I get an error message when the program loads relating to a missing framework. It tells me that the program may not work properly. However I have been able to get your file to run OK eventually. It is a dose escalation study....very early development. No study design per se is given. After this success I then tried the data set I have already studied for dose proportionality by dose-normalized BE in Phoenix. There are only two doses given to 20 subjects cross-over design. So using your structure I set up the input for LME model. The model was lndose as given by you. I was able to get an evaluation for residual error for both Cmax and AUC0-t. The values were indeed very similar to what I had obtained in PHoenix (e.g. Cmax CV(%) was 19.9 compared with 20.06 (BE result). The CV(%) for AUC0-t ws 12.2 compared with 12.6% by BE approach). Other worker has reported CV(%) of 0.1 for AUC0-t. I am wondering if using SAS you can get a result of 0.1. For Cmax other worker reports CV% 10.1. I do not think using SAS can give such a difference?

Complete thread:

UA Flag
Activity
 Admin contact
22,988 posts in 4,825 threads, 1,654 registered users;
100 visitors (0 registered, 100 guests [including 3 identified bots]).
Forum time: 16:17 CEST (Europe/Vienna)

The whole purpose of education is
to turn mirrors into windows.    Sydney J. Harris

The Bioequivalence and Bioavailability Forum is hosted by
BEBAC Ing. Helmut Schütz
HTML5