Log in
RegisterPE outside the acceptance range [Power / Sample Size]
Dear Helmut,
You are right, it was partial replicate design.
The low power for Cmax, probable reasons may be as following,
Regards,
Jay
You are right, it was partial replicate design.
The low power for Cmax, probable reasons may be as following,
- Lower Sample size
- PE outside range
Regards,
Jay
Complete thread:
- Post hoc Power Jay 2016-01-08 06:49
![[Mix]](https://static.bebac.at/img/mix.png "open in Mix view")
- Post hoc Power ElMaestro 2016-01-08 15:07
- Post hoc Power Helmut 2016-01-09 14:21
- Post hoc Power Jay 2016-01-11 10:59
- PE outside the acceptance range Helmut 2016-01-11 14:02
- PE outside the acceptance rangeJay 2016-01-13 08:24
- Power for PE outside the acceptance range d_labes 2016-01-13 11:59
- PE at border of the AR: power ≡ 0.05 Helmut 2016-01-13 12:38
- PE at border of the AR: power ≡ 0.05 ? d_labes 2016-01-13 13:21
- PE at border of the AR: power ≤0.05! Helmut 2016-01-14 01:29
- UMP - uniformly more powerful test d_labes 2016-01-15 20:08
- PE at border of the AR: power ≤0.05! zizou 2016-01-24 22:12
- Smoothing artifact Helmut 2016-01-25 14:15
- PE at border of the AR: power ≤0.05! Helmut 2016-01-14 01:29
- PE at border of the AR: power ≡ 0.05 ? d_labes 2016-01-13 13:21
- PE outside the acceptance rangeJay 2016-01-13 08:24
- PE outside the acceptance range Helmut 2016-01-11 14:02
- Post hoc Power Jay 2016-01-11 10:59
Ing. Helmut Schütz