Bioequivalence and Bioavailability Forum • WNL Calculation of partial areas

WNL Calculation of partial areas > tlast with BQL= 0 rule [Software]

posted by ElMaestro – Denmark, 2018-07-14 00:25 (2107 d 13:17 ago) – Posting: # 19054
Views: 7,133

Hi Babe_Ruth,

❝ When I set BQL to "no value," then it (blah)

❝

❝ However, when I set BQL to 0, it uses a linear-trapezoidal rule: (Clast + 0)*(T16 - Tlast)

❝ Nowhere in the documentation does it say that this was the plan.

Do you mean it uses AUC_partial=0.5*(Clast + 0)*(T16 - Tlast) ?

If yes, then this is expected behaviour: Remember that you distinguish between BLQ, missing and a zero.
If you set it to zero then it means you tell WNL to believe that the value is really zero in contrast to not measured. Thus, it was quantifiable so now the last quantifiable value is no longer at t=12 but at t=16. The residual area will naturally also be zero, so the extrapolated area is zero percent. I'd say you are within expectations and specifications.

—
Pass or fail!
ElMaestro

Complete thread:

WNL Calculation of partial areas > tlast with BQL= 0 rule Babe_Ruth 2018-07-13 21:36
- WNL Calculation of partial areas > tlast with BQL= 0 ruleElMaestro 2018-07-13 22:25
- BQL = 0: bad rule Helmut 2018-07-13 23:28
  - BQL = 0: bad rule Babe_Ruth 2018-07-16 15:02
    - BQL = 0: bad rule Helmut 2018-07-16 16:02
      - BQL = 0: bad rule martin 2018-07-16 20:03
  - BQL = 0: bad rule martin 2018-07-16 20:43
- is zero positive? mittyri 2018-07-13 23:31
  - sgn(0) = 0 Helmut 2018-07-13 23:58
  - is zero positive? Babe_Ruth 2018-07-16 14:49